A professional job at a garage is recommended for large, deep dents or terrible damaged surfaces. The fee for fixing hail damage at garage is quite cheap and fast and sometimes require a new paint job. Besides, it is good ideas to compare offered services and prices at various auto supply stores to find out which package works best for your car’s situation and your wallet.
Restoring your hail damaged vehicle ? If you are considering learning the skill of how to do paintless dent repair, it’s important to understand that it isn’t simply a matter of “popping” a dent out and expecting that the body will be perfect again. PDR involves a very slow and methodical process that requires special tools, a certain level of knowledge and skill, and a great deal of patience. Some dent repairs, even on small dents, can take up to two hours.
In the first place let’s start with some car paint care tips: Clay: You could also obtain a better finish and a prominent shine if you use good quality clay. Before the clay is applied to the surface, make sure the car is cleaned with paint cleaner. Always remember to use the right applicator pad or a soft terry towel when working on the car’s exterior, to avoid scratching the vehicle. If you don’t know how to use detailing products or clay on your car, view online tutorials and easy do-it-yourself guides to complete the task easily.
So, we’ve explained what the procedure looks like — assuming it was done properly. And as you could probably guess there are a lot of ways an amateur or first-timer can get it wrong. It’s different than most other car repairs because it’s not about mechanical prowess; it’s more about control and the ability to maintain a steady hand and a gentle pace. You can’t rush it. The problem is, once a sheet metal repair starts to go awry, you’re usually much, much worse off than if you’d just left it alone. Metal holds its shape, but only to a certain point. Let’s say you get a dent in the hood — nothing too drastic, just a shallow, even dent with no sharp creases in an area that’s pretty easy to reach. You think it’ll be easy to pop it out on your own, so you begin to massage the underside while holding your shaping tool in place. You’ve made good progress so far, and a casual observer wouldn’t even notice the flawed area. But it’s not exactly perfect, and since it’s been fairly easy to this point, you decide to keep massaging the area to make it flawless. After a few more minutes of massaging, you realize that you’ve pushed it just a little too far. And now you’ve got this flabby area on the hood where you stretched out the metal. And there’s no easy way to shrink it back down. Keep going and it’ll stretch even more. Lesson learned. Read more details at Automotive hail repair.